Forum
Register
If you have trouble registering then email support @ iforpowell.com and I can force things though.
The system is not that good but I prefer to spend my time working on IpBike than trying to set up an alternative. It is at least good at keeping the spam away.
It is advisable to 'copy' before you try and post as the captcha stuff is a bit to agresive and the back buttone is not working for everyone. You can at least then paste and have another go.
Apps »
IpBike » Non-active timeout
Started by hrocs Jul 07 2017, 19:42
hrocs
Posts: 26 |
Jul 07 2017, 19:42
Can me anybody explain what means this menue option?
Main bike settings / Trip control / Non-active timeout
If my speed is zero, I should read zero speed.
If my cadence is zero, I should read zero cadence.
What is the sense, to set this value 60 seonds???????
I had it at 3 sec, and my cadence zeroed only after 3 sec.
If I stop, my active time counts 3 sec more....why?
At today ride I set the value to 2 sec, I had confused cadence and power data. I set it back to 3 sec.
My powermeter delivers the cadence data. If my power is zero, then I read zero power.
But if my cadence is zero, I have to wait 3 seconds until it will zeroed.
|
|
Ifor
Moderator Posts: 939 |
Jul 19 2017, 21:35
Your active time should count 3 seconds more then when it is seen you have stopped 3 seconds get taken off again so the total should be correct still.
|
|
hrocs
Posts: 26 |
Jul 22 2017, 17:13
OK, but the cadence 3 sec. "non active timeout" I still dont understand.
My rear Powertap hup delivers power and cadence data.
Power read is OK. If power is zero, I read immediately zero.
For cadence I have to set this "non active timeout" .
|
|