Forum

Register

If you have trouble registering then email support @ iforpowell.com and I can force things though.

The system is not that good but I prefer to spend my time working on IpBike than trying to set up an alternative. It is at least good at keeping the spam away.

It is advisable to 'copy' before you try and post as the captcha stuff is a bit to agresive and the back buttone is not working for everyone.  You can at least then paste and have another go.

Apps » IpBike » Working better with non-beta Sensors

Started by goosieb Jul 19 2017, 12:08

goosieb Posts: 70	Jul 19 2017, 12:08 I've found using the beta Sensors and a Wahoo Tikr HRM (now quite old and mistakenly washed a number of times), it doesn't work as well as it used to with BTLE- it almost never connects. I instead use ANT+ for the HRM and it connects immediately, but not long into a ride or run I get a number of HR Sensor Stopped audio messages and I find later there is a gap in the GPS recording of about 30 seconds. I've found I haven't yet (touch wood) had this problem since I reverted to the non-beta version of Sensors.
goosieb Posts: 70	Oct 31 2017, 09:13 I think experience on the non-beta version shows me that some problems with the beta version are relating to whether the app thinks the HRM has stopped or not. When it thinks it has stopped, it also restarts the GPS. However, my HRM doesn't ever stop or loose connection, but it does physically loose connection to my heart. When I start a ride or run the HRM shows reasonable varying data, then as the ride/run gets going, my skin dries and gets cold and the HRM chest strap looses connection to ME. Then, later as I eventually get warm and I get a flush of very light sweat, the HRM gets connected again and ipbike starts shouting out zone changes and max HR at me. This happens every time; it's me not the sensor. However, the beta version takes it too seriously and puts holes in the GPS recording.