Ifor's orienteering training log


Page 1 of 2  > >>

Jan 3, 2012
Category: Website
Posted by: ifor
Forum added
Jan 2, 2012
Category: Website
Posted by: ifor
OK upgraded the site CMS system just now to 1.10.2.  hope everything still works.
Oct 30, 2011
Category: Website
Posted by: ifor
Added a blog section to the site.  I need to sort out the templates a bit as things are not looking so good.
CMS - 1.10.3 - Hyacinthe


Password (again)*
email address*

Enter the text from the image:
This is a captcha-picture. It is used to prevent mass-access by robots. (see: www.captcha.net)

I have already completed the registration form, but did not receive an email, can you please re-send it Click Here
Apps » IpBike » Why am I getting 0 for Virtual Power?

Started by LisaB Mar 20 2021, 21:50
Posts: 5
Mar 20 2021, 21:50

Hi, I'm a new user of IPBike and I am very impressed.

But I have run into a problem trying to set up virtual power. While riding, my screen displays 0 for Power, 5s Power, 30s Power, and Virtual Power. But the components of VP Rolling, VP Drag, VP Elevation, and VP Acceleration all display nice, positive values. All my speed and distance values are reasonable, just not the power.

I have checked the checkbox Enable Virtual Power in the Bike Editor. I have also set Non-active power timeout to the maximum of 60 sec in Settings.

My setup:
*indoor stationary bike with BLE Garmin speed sensor
*no other sensors

Thanks, Lisa

Posts: 5
Mar 21 2021, 02:13

I figured it out --

In Bike Editor, I had "VP - Colories Mode" set to user defined my_vp without having it defined. Set to Road Bike instead, and getting reasonable values now.

Previous page: Forum